Why the fingers matter on your strap cutter
The Cobra AK20 Plus Strap Cutting Machine relies on a set of fingers to guide and hold leather strips as they pass through the cutter. Over time, these fingers wear down, bend, or lose their grip, which can lead to uneven strap widths or feeding problems. Replacing them restores consistent performance and helps protect the blade from unnecessary stress.
If you notice your straps coming out uneven or the machine struggling to feed material smoothly, worn fingers are often the first thing to check.
When to replace the fingers
There is no fixed schedule for replacing the Cobra AK20 Plus fingers; it depends on how often you use the machine and the types of leather you cut. Frequent use with dense or thick leather will accelerate wear. Inspect the fingers regularly for visible damage, such as cracks, bending, or a smooth, polished surface that no longer grips the leather.
If you are unsure whether your fingers are worn, compare them to a new set. Even a small difference in shape or surface can affect strap quality.
What to order
- Cobra AK20 Plus Fingers: Cobra AK20 Plus Fingers are replacement fingers for the Cobra AK20 Plus Strap Cutting Machine. Make sure you order the correct part for your specific machine model to ensure a proper fit and function.

Cobra AK20 Plus Fingers - Cobra AK20 Plus Fingers: The current shipping time for this item is 7-10 days. Plan ahead if your machine is out of service; you may need to wait over a week for the replacement to arrive.
How to replace the fingers
Replacing the fingers is a straightforward process, but always follow the safety instructions in your machine manual. The exact steps may vary, so refer to your Cobra AK20 Plus documentation for specific guidance.
- Power down and unplug: Before any maintenance, disconnect the machine from power to prevent accidental starts.
- Remove the old fingers: Locate the fingers on the cutting head. Depending on your machine's design, they may be held by screws or a quick-release mechanism. Carefully remove them, noting their orientation.
- Clean the mounting area: Wipe away any leather dust or debris from the mounting surface so the new fingers sit flush and secure.
- Install the new fingers: Position the new fingers exactly as the old ones were, then tighten the fasteners evenly. Avoid over-tightening, which can distort the fingers.
- Test with scrap leather: Run a few pieces of scrap leather through the machine to confirm the straps come out even and the feed is smooth.
Maintenance tips to extend finger life
To get the most from your Cobra AK20 Plus fingers, keep the cutting area clean and free of debris. Leather dust and oils can build up on the fingers, reducing their grip and accelerating wear. Wipe them down after each session and check for any signs of damage.
Also, make sure the blade is sharp. A dull blade puts extra strain on the fingers and can cause uneven cuts. If you are not comfortable sharpening the blade yourself, consider having it serviced by a professional.

