Infinity Snake Bracelet Button: Setting It on a Leather Cuff

By Tandy Leather — Tandy Leather, Inc. | Published: 2026-11-03

Category: Anleitungen

Learn how to set an Infinity Snake Bracelet Button on a leather cuff, from sizing the strap loop to finishing the closure without splitting the leather.

Quick answer

Set the Infinity Snake Bracelet Button by attaching one end of the cuff to the button and forming a loop on the other end sized to the button's 0.31 in. strap loop. Work the leather slowly and test the closure before finishing the edges.

Why the strap loop size matters more than the button size

The button diameter is 0.5 in., but the critical measurement is the 0.31 in. strap loop. If the loop is too tight, the cuff will not close over the button; too loose, and the bracelet will slip off. Cut and skive the loop end before punching the button hole so the leather can fold without bulk.

When to choose this button over other bracelet fasteners

This button works best on cuffs where you want a decorative, low-profile closure that is easy to fasten one-handed. It is not a substitute for a buckle or snap when you need adjustable sizing or heavy-duty retention. For wide cuffs or stiff leather, test the loop with a scrap piece first.

Steps to set the button closure

Measure and mark the loop end: Wrap the cuff around your wrist and mark where the loop end meets the button position. Leave enough leather to form a 0.31 in. loop, then skive the end to reduce thickness. Check the mark against the button's 0.5 in. diameter before cutting.
Punch the button hole: Use a hole punch sized slightly smaller than the button neck, centered on the loop end. Start with a smaller hole and enlarge gradually. A hole that is too large will let the button pull through; test with the actual button.
Fold and secure the loop: Fold the loop end over and stitch or rivet it in place, keeping the loop opening at 0.31 in. Test the button through the loop before finishing. If the loop is too tight, remove stitches and adjust before adding adhesive.
Attach the button to the opposite end: Set the button on the other end of the cuff according to the button's attachment style. Ensure the button sits flat and secure. Dry-fit the closure on your wrist before final finishing.
Finish and test the closure: Burnish or edge-paint the loop and button area, then fasten and unfasten the cuff several times. Adjust if the loop stretches or binds. A well-set closure should hold securely but release with moderate pressure.

Product facts

Infinity Snake Bracelet Button: Nickel-free Infinity Snake Bracelet Button with a 0.31 in. strap loop and 0.5 in. button diameter. The nickel-free construction suits sensitive skin, and the loop size tells you exactly how much leather to leave for the closure.
Infinity Snake Bracelet Button